|
To summarize the sequence of working is the following one:
1. From EVOSOFT, the different parameters of the meter are selected for a set of measurements to be carried out. For this purpose, you can use the Assistant for creation of groups. The assistant will guide us to create the structure of the measurements, which is the base of the datalogger.
2. Once the structure of measurements is created, it is dumped from the computer to the USB device. The memory is then connected to the meter, and through the command New measurement of the TOOLS > DATALOGGER menu, it executes all the programmed measurement procedures, storing the results in the same USB memory device.
3. The data, figures and pictures gotten, can then be loaded on the computer again, where EVOSOFT will allow its viewing and processing.
Finally, the software allows generating detailed reports of the installations, which can be customized by the customer to make them fit with its needs.
EVOSOFT will make easier the following tasks:
• Create structures of measurements to be used with the datalogger of the meter, and store them in the USB memory device.
• Use assistants to create groups that compose the structure of the datalogger.
• Save in a Data Base all the programming parameters, and reuse them in future works.
• Restore the information of the datalogger from the USB memory, and view the measurements, the figures of the spectrums (in peak and average mode) the oscillogram of one specific CVBS line (for analogue TV) and one capture of a Picture of the TV channel.
• Create customized reports from different patterns, which can be created or adapted with the pattern editor.
• Create, Save and Restore programs that, without being part of the datalogger, they can be used by the meter in the program navigation mode.
User's Manual EVOSOFT (.pdf) (1.7 MB)
|
